- Vented cable provides real time barometric compensation
- Simple two-wire connection
- Output signal is compatible with most telemetry, SCADA and PLC systems
- High noise immunity on long cable runs
- Wide range of supply voltage (7.5VDC-35VDC)
- High accurate water level measurements
- Reverse polarity protected
4-20mA Pressure Transmitter
The 4-20mA Pressure Transmitter is easily integrated into an existing SCADA system, digital display and 3rd party data logger. It will provide a continuous, accurate water level reading for a wide variety of applications.
A two-wire 4-20mA Pressure Transmitter current configuration is used with our pressure transmitter which is the most widely used signal transmission for transducers in industrial environments.
“It is the Distributor’s and/or User’s responsibility to ensure chemical, temperature, radiative, and shock compatibility with their site(s) before, during and after deployments. Not doing so will void any and all warranties”
|# of Data Points||N/A|
|Accuracy %FS||+/- 0.05|
|Stability %FS/Year||+/- 0.20|
|Pressure Ranges||10m(30ft), 30m(100ft), 60m(200ft), 200m(650ft)|
|Operating Temperature||-20°C to 80°C|
|Supply Voltage||7.5VDC - 35VDC|
|Expected Battery Life||N/A|
|Wetted Material||316 Stainless Steel & Delrin®|
|Transducer Material/Length||316 Stainless Steel Piezoresistive Silicon/130mm|
|Note:||In "Log Time" mode the dipperLog increases the readings from 1 second by an additional 1 second for 255 readings. The final reading interval is 4 min. and 14 sec. and the logger then stops logging. This mode logs for a total of 9 hours before stopping.|
|Direct Read Cable||6.25mm diameter, Polyurethane jacketed, 4 strand insulated T.C conductors. 1 strand T.C drain line, 2.5mm nylon vent tube. Reinforced with Kevlar and an aluminium shield (Weight 34g/m)|
Digital Display 4-20mA – PN# 5031
The Digital Display 4-20mA unit provides real time readings of height of water above the transducer in either meters or feet. Other units of measurements are available upon request. The display is loop powered, there is no need for an extra power supply.